Solid steel ramps for custom fitting fiber optic, ivory and brass bead sight blades. Available in two heights and four barrel contours to fit a wide selection of current and older production rifles. Ramp attaches to barrel with a single screw under the sight body and solder; flat base is drilled for two mounting screws.
SPECS: Steel, blue, polished finish. .340" (8.6mm) wide. 2" (5cm) long. Height is measured from the top of barrel to the bottom of the dovetail.
More...
Customer ratings for MARBLE ARMS RIFLE DOVETAIL FRONT RAMP .625" ID .100" BLACK
Number of ratings: 1
From brownells.com: 1
Average rating: 4
Modest Machining Required(24/10/2012)
Well made products my only complaint is that the counter sink hole in ramp was not machined enough to allow the attachment screws to fit flush. One has to use lapping compound to achieve a good fit. Both ramps I bought required this minor machining.
Product no.: 579000034 MARBLE ARMS RIFLE DOVETAIL FRONT RAMP .625" ID .100" BLACK Mfr Part: 072310871373007190 Solid steel ramps for custom fitting fiber optic, ivory and brass bead sight blades. Available in two heights and four barrel contours to fit a wide selection of current and older production rifles. Ramp attaches to barrel with a single screw under the sight body and solder; flat base is drilled for two mounting screws.
Solid steel ramps for custom fitting fiber optic, ivory and brass bead sight blades. Available in two heights and four barrel contours to fit a wide selection of current and older production rifles. Ramp attaches to barrel with a single screw under the sight body and solder; flat base is drilled for two mounting screws.
SPECS: Steel, blue, polished finish. .340" (8.6mm) wide. 2" (5cm) long. Height is measured from the top of barrel to the bottom of the dovetail.
More...
Customer ratings for MARBLE ARMS RIFLE DOVETAIL FRONT RAMP .625" ID .100" BLACK
Number of ratings: 1
From brownells.com: 1
Average rating: 4
Modest Machining Required(24/10/2012)
Well made products my only complaint is that the counter sink hole in ramp was not machined enough to allow the attachment screws to fit flush. One has to use lapping compound to achieve a good fit. Both ramps I bought required this minor machining.