This NT1500 Neck Turning Kit includes all four of the basic tools necessary for successful neck turning. Kit includes our NT1500 Neck Turning Tool, a Generation II Expander Die, a Neck Turning Mandrel and an Expander Mandrel all at a discounted price. You can also purchase your neck turning tool kit with our Sinclair Storage Case (80-15XX).
More...
Customer ratings for SINCLAIR INTERNATIONAL 6.5MM DELUXE NECK TURNING KIT
Number of ratings: 2
From brownells.com: 2
Average rating: 4.5
Great tool(28/10/2011)
I have turned necks before using RCBS tools mounted on the case trimmer. This tool is far and away more reliable and accurate.
I turn the cases with a case holder in a power screwdriver because I have a lot of cases to turn and limited time to do it. The finish obtained is far and away better than anything else I have tried or seen short of a lathe.
I use a little cutting oil on the inside and outside of the case and feed as slowly as I can to get a good finish. I have also used it to remove donuts from older cases - works like a charm!
Amazing results!(31/07/2015)
Takes a few minutes to get set up,...once adjusted and locked in,..works like a charm! Don't even consider using the hand turning tool, although it does work,..you can save A TON of time and get 100% better end results if you order the Lee 3 jaw chuck # 100-010-142WB and case spinner stud # 100-010-141WB
I'll attach a pic of an old piece of 6br brass I took two passes with the Lee drill attachment at slow speed (I think it's around 750rpm) and did a quick clean up with a 0000 nylon scuff pad.
This NT1500 Neck Turning Kit includes all four of the basic tools necessary for successful neck turning. Kit includes our NT1500 Neck Turning Tool, a Generation II Expander Die, a Neck Turning Mandrel and an Expander Mandrel all at a discounted price. You can also purchase your neck turning tool kit with our Sinclair Storage Case (80-15XX).
More...
Customer ratings for SINCLAIR INTERNATIONAL 6.5MM DELUXE NECK TURNING KIT
Number of ratings: 2
From brownells.com: 2
Average rating: 4.5
Great tool(28/10/2011)
I have turned necks before using RCBS tools mounted on the case trimmer. This tool is far and away more reliable and accurate.
I turn the cases with a case holder in a power screwdriver because I have a lot of cases to turn and limited time to do it. The finish obtained is far and away better than anything else I have tried or seen short of a lathe.
I use a little cutting oil on the inside and outside of the case and feed as slowly as I can to get a good finish. I have also used it to remove donuts from older cases - works like a charm!
Amazing results!(31/07/2015)
Takes a few minutes to get set up,...once adjusted and locked in,..works like a charm! Don't even consider using the hand turning tool, although it does work,..you can save A TON of time and get 100% better end results if you order the Lee 3 jaw chuck # 100-010-142WB and case spinner stud # 100-010-141WB
I'll attach a pic of an old piece of 6br brass I took two passes with the Lee drill attachment at slow speed (I think it's around 750rpm) and did a quick clean up with a 0000 nylon scuff pad.