Hardened stainless steel neck bushing designed for precision sizing in .001” increments with a .003” taper for fine-tuning neck tension.
For emergency use or fine-tuning, the bushing can be flipped to achieve tighter sizing if brass no longer holds the bullet properly.
Compatible exclusively with L.E. Wilson dies and not interchangeable with Forster or RCBS dies; two methods provided for selecting the correct bushing size.
Redding's Titanium Nitride Neck Bushings are heat treated steel bushings with an additional Titanium Nitride coating for increased hardness and reduced friction.
The bushings are available in a range of sizes from .185" to .368", in .001" increments.
The specific size of the bushing is indicated by the last three digits of the part number, with this particular bushing being .336" in diameter.
The Neck/Shoulder Sizing Bushings are designed for Short Action Customs Modular Sizing Dies, allowing precise neck sizing and bump adjustment for cartridges.
They feature a new internal bushing geometry aimed at reducing neck runout and enhancing loaded cartridge concentricity.
Constructed from 17-4 H900 stainless steel with a heat treatment for durability, these bushings boast a smooth interior and slick exterior finish.
Forster neck sizing bushings are designed exclusively for use with Forster Precision Plus Bushing Bump Dies and are not compatible with other brands.
The bushings are available in .001 inch increments within the range of .281 to .343 inches.
All Forster bushings undergo cryogenic treatment for enhanced smoothness and durability.
RCBS Steel Neck Bushings provide precise tension on bullets when used with RCBS Gold Medal Match sizing dies, improving accuracy and extending case life.
For optimal results, it is recommended to use high-quality brass with consistent neck thickness and to lubricate cases as bushings come in bare steel.
To select the correct bushing size, subtract .002"-.003" from the loaded cartridge's outside neck diameter or calculate based on case neck wall thickness and bullet diameter.
RCBS Tungsten Coated Neck Sizing Bushings provide precise bullet tension without needing traditional case lube thanks to their Tungsten Disulfide coating.
These bushings are self-centering, ensuring proper alignment with the case neck, and are to be used exclusively with RCBS Gold Medal neck sizing dies.
It's recommended to have neck bushings in sizes one to two above and below the target diameter for optimal results and consistent-shooting ammunition.
TRIEBEL Seaterhead is designed for calibers 10,3/.415 and is used as an accessory for Seater with Crimp and Bench-Rest-Seaters.
The Seaterhead is manufactured by TRIEBEL, a company known for its precision shooting equipment.
It falls under the main category of Neck Size Bushings and has a diameter specification of 0.415 inches.