Attributes
- Cartridge: 45 (Long) Colt
- Style: Rimmed Pistol
- Delivery weight: 0.113kg
- Shipping height: 20mm
- Shipping width: 20mm
- Shipping length: 142mm
Product no.: 184051455
Mfr. No.: F45LCC
Rimmed Finisher Style Reamer fits .45 Long Colt CylinderSPECS: PISTOL REAMERS - 6, right-hand cutting, straight flutes. Solid pilot. Integral throat. Available in two different pilot diameters: Barrel for Single Shot or Semi-Auto pistol and rifle barrels; Cylinder for Revolver cylinders. 7/16" dia. shank with 3/8 " square drive, depending on caliber, ¼" round shank on .22 RF. Stocked in Finisher style only. ORDERING: Advise: 1) Stock #. 2) Cartridge Caliber and Name.
Note: If you do not see the caliber you are looking for below, please feel free to contact our Special Orders Department, as many additional items are avaliable from Clymer.
Great for reworking tight chambers. 04/08/2015
I used this to correct a 40 S&W barrel that had an undersized chamber and rough throat. The finish produced is outstanding. Can be used by hand with a tap wrench and good cutting oil like Do-Drill. Just cut a few turns, back out while still spinning, wipe or blow off chips, re-oil and go again. Use extreme care when you are getting close to shoulder area so you just clean up the shoulder. If you have depth mikes, check the headspace depth so as not to exceed SAAMI specs which can be printed off the SAAMI website for free.
Very nice reamer 01/11/2009
Not much you can say about a reamer. It's very clean,very sharp and over all nice grinding.
We encountered an error while loading this content. Please refresh the page to continue. If the issue persists, contact our customer support.